anybody know the meaning of this code?
thanks!
anybody know the meaning of this code?
thanks!
Portable Manual iR7105/7095/7086 Series
Chapter 3 Error Code
Search to internet......
The Road will be Mastered by >>> the Going...
E197 is a laser motor communication fault
E197 error code.
This code refers to a communication error with the laser scanner motor (M4).
also check>>>
1) Pull the separation / transfer corona unit out.
2) Inspect the bias cable located to the right of the sep/trans assembly holder in the rear of the transport assembly.
3) Tighten and adjust tube if needed ,confirm there is no short between the screw and cable
see tech pub.>TP06-1.pdf
or check>
E197 can be cause by a pinched wire between the Video PCB and the Relay PCB. Check the wiring and cut wire ties coming from connector J1405 on the Video PCB. The part number for the harness is FM2-5427-000.
Video.jpg
Although this code refers to a communication error with the laser scanner motor (M4),
it has been found that a fixing bias short will cause the E197.
If the fixing unit was recently rebuilt, check to make sure that the orientation of the fixing bushings and bearings are in it's correct position.
E197~1.jpg
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
turned out to be a bearing leaving metal filings in the back of the machine was causing a short. thank you to all whom responded. i appreciate it.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
thanks teckat!
Bookmarks