Thanks:
0
Likes:
0
Dislikes:
0
-
SRAM could be an issue/
if replaced or swapped clear MN-CON=MN-CON clears the old data. Once cleared the machine will reboot itself and rewrite the data to the new SRAM PCB.
****do the clear after replacing pcb.
make sure to print out the P PRINT settings first
had a few iRC5180's with E611- I believe the HD format & re-load of Firmware worked to resolve issue
when u get back that iR5065/
do a complete format of the HD/ then re-load v55.01V3
REMINDER>>>>
You will not be able to download G3Fax twice in succession. (Once downloading is executed, the board will be reset, causing download mode to end.)
Be sure never to turn off the machine while it is executing a downloading session or writing downloaded system
software. Otherwise, the write operation (to the flash ROM DIMM of the G3 fax board) may fail, preventing
board functions.
In the event the board fails to function, be sure to replace the flash ROM DIMM found on the G3 fax board.
Last edited by teckat; 04-16-2011 at 02:01 PM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks