From tech pub>>>>>>>>>>>>>>>
Error 03130031-2F13
1. Check for abnormal carriage drive load
a. Faulty carriage idler pulley (broken spring hook, dropped belt teeth)
b. Faulty linear encoder sensor
( soiled or flawed linear encoder, or improper mounting position / tension )
c. Soiled carriage rail ( unlock the purge unit and move it by hand)
* Never oil the carriage rail!!!
d. Improper carriage belt tension
e. Foreign matter inside the rail (cutter, cleaning brush, bearing out of position)
2. Check carriage motor drive at electrical fault
a. Drive signal / voltage error
Check main controller J3101-1 for 32v during initial operation at start up
b. Upgrade firmware if it is v1.31 or any earlier release
c. Poor connector contact / wiring
d. Faulty motor (replace the carriage motor and / or the main controller )
If the error occurs before the start of printing, the main controller is most likely faulty.
The problem is reported to have occurred as a result of a faulty cutter, depending on the version of firmware.
or>>>>>>>>>
If Replacing the Print head does not resolve the problem. Try re-seating the Flex Cable,
cleaning the Linear Scale and the
Carriage Rail may clear the code.
Bushings in Carriage Unit get lubricated in the factory.
* Never oil the carriage rail!!!
Attachment 9590
Bookmarks