I am going to work for the first time on Canon Imagerunner C3200, could somebody tell me how to change the fuser assy.
I am going to work for the first time on Canon Imagerunner C3200, could somebody tell me how to change the fuser assy.
If you are just swapping the assembly it is two screws holding the fuser in one in the front and one in the back. Always check the NIP pressure when installing a new fixing unit.
Accidents don't just happen. They must be carelessly planned.
I am sorry, i don't want to be a pain, but how to check the NIP pressure.
Enter service mode, and navigate to copier>function>fuser>nip-chk
<FIXING>
Automatically adjusts fixing unit.
NIP-CHK
Fixing nip width automatic measurement output.
Operation 1) If the finisher is connected, remove it from the copier and pull out the
method lattice cable.
2) Place A4 (LTR) size paper in the manual feed tray.
3) Press the OK key (the paper in the manual feed tray is fed).
4) When the fed paper is pressed by the fixing roller, it stops, and is delivered
about 15 seconds later.
5) Check that the nip width of the delivered paper is the standard value.
F05-701-02
6) If the standard value isn’t met, adjust the value. See the Printer Manual,
Chapter 6, “Fixing System”, 4. “Disassembly and assembly”, 4.2 “After
fixing unit disassembly”.
7) After completing the operation, output a test print
(COPIER>TEST>PG>TYPE (6): Grid).
Remark The paper is delivered from the side paper delivery tray.
What mrfixit said is spot on. Thanks for the assist!!!
Accidents don't just happen. They must be carelessly planned.
Bookmarks