I have this copier showing this error
not have the service manual
anyone have any idea what can be
I was told that may be in the G-chip?
not found in the manual
and a board
appreciate everyone's help
Att:
Roberto
I have this copier showing this error
not have the service manual
anyone have any idea what can be
I was told that may be in the G-chip?
not found in the manual
and a board
appreciate everyone's help
Att:
Roberto
Poor Contact Occurs PCB
Remove the screws fixing the controller box
cover
ScreenShot003.jpg
Hold the Sub PCB firmly with both hands, and
then pull out it from the main board.
ScreenShot005.jpg
Clean the terminal (both adverse and back sides)
of the detached PCB with lint-free paper
impregnated with alcohol.
ScreenShot006.jpg
With the Sub PCB [4] temporarily inserted,
temporarily fix the Sub PCB support plate [5]
with 2 screws. (Leave a space of approx. 1mm
between the seating surface of the screws and the
support plate.)
ScreenShot007.jpg
Good luck.
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
E748-4000 CL2 board-dependent, board error.
A packet timeout condition has occurred in the G-Chip loopback.
1. Disconnect and then connect 4 to 5 G-chip boards several times.
2. Replace the G-chip board.
3. Replace the main controller PCB.
here is the full pdf below that zoraldinho posted
TP08-1.pdf
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks