IR105 with E350-001

[Pilotpor]

My IR105 show Error Code E350-001. That's no informaton in service manual.
What happen with my machine. Please help me! Thank you.

[V-P]

I don't know exactly what but :
It is related to the brains of the copier. Probably main board or communication of main board.
Try to remove and re seat motherboard.

I found this:
E350 Faults on ECO ID PCB. A check is made at poweron.
1. Ensure connector J1213 on the Main Controller PCB is connected.
2. Replace ECO ID PCB

I am sure Teckat knows the exact issue.

[zoraldinho]

V-P is wright.It's communication of main board.Re seat connectors and install System Software Ver. 86.02.

I hope you are not playing with the counter reset.

[V-P]

you didn't mess with the counter - did ya ???

[Pilotpor]

V-P,you mean counter pcb?

[victor_v]

Hi,
E350
1. The bar code data for backup and the attached bar code data do not match
2. A fault in the Serial No. PCB is detected when power is turned ON

[zoraldinho]

you didn't mess with the counter - did ya ???

Good point

[V-P]

I mean...

It's ok if you messed with counter.

All you have to do is give a beer to me and zoraldinho

and we tell you how to fix it ....lol

[CT Copier Repair]

playing with the counter will screw ya

make sure the bc is clean and readable
make sure the eco bd is seated and it wasn't swapped out
like trying to play with counters

sheeshs resetting counters is easy and not as involved as one might think
however its illegal and immoral and just plain scumbag move

[Pilotpor]

How can I do with my machine?
Where is the ECO ID PCB?because i'm not technician.