machine is not detecting the finisher (N1), paper trays 3, 4 and the high capasity tray on the side.
machine is not detecting the finisher (N1), paper trays 3, 4 and the high capasity tray on the side.
the fuse is good, the machine was recently move from irvine to me (san diego)
yes, i actually bougth a new one
only change the fuse on the board
i changed it on figure Z91
That lower Cassette feeding unit supplies power to all those options /
there is an inter face square plug/ that goes from unit to printer/ unscrew cover on cable/ look inside to see if the two small connectors are seated in place/make sure that cable has no damage
PLUG.JPG
Check for 24VDC at connector J486 pin 2 on the Pedestal Controller PCB.
PL.JPGPLUG3.JPGPLUG1.JPG
Last edited by teckat; 06-24-2011 at 09:10 PM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
It just dawned on me... DOH!!!!!!
If the power cord is not plugged into the proper place, only the main body gets power, and all accessories do not! I believe you place the power cord into the pedestal/paper feed unit, and the short plug from the pedestal unit into the copier main body...
"Once a King, always a King, but once a Knight is enough!"
Give mrfixit51 a CIGAR
cra08-color.jpg
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
I believe that accesory power plug needs to go into the middle of the three outlets down there on the pedastal. Good observation Mrfixit51!!!
Accidents don't just happen. They must be carelessly planned.
Good point>>>Pictures tell the story
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks