Thanks: 0
Likes: 0
Dislikes: 0
Serial Number pcb. works in conjunction with the Main Controller and the Counter Pcb.
that is where the speed of similar models is controlled
The Serial Number PCB's are restricted. The Serial Number PCB can only be obtained by contacting the Canon Technical Support Hotline
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Swapping around these serial number PWB's is an excellent way to make your MFP into a doorstop. Don't do it. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
My machine use 120V and I saw on the rear side this serial number: MPG 63013
The front side iR 3300, So as you said I have to change serial number PCB and counter PCB or Main controller PCB.
Thanks for your suggestion.
MPG is the serial prefix for an IR-2200. They switched the front door on you.
Accidents don't just happen. They must be carelessly planned.
Originally Posted by toantam
CALL A COP !!!!!!!
OLD saying_ "Sucker born every minute"
How are u timekeeping this printer ??
Canon test are from a single piece of paper placed on the glass/with no sorter attached/and paper pulled from a cassette.
You can not get a serial #PCB Board / they are only sent by CANON
Counter Memory, Serial Number and Main Controller PCBs work as a set and are considered the “Soft Counter Circuit”. The Counter Memory PCB is electronically stamped with the serial number from the Serial Number PCB.
Neither the Counter Memory PCB nor the Serial Number PCB can be swapped to other equipment. The Counter Memory PCB keeps track of the total count, which cannot be erased or changed. The service counters are retained by the Main Controller. These counters can be reset manually through service mode.
Hit counter check and see what the model and serial number says.
If u don't see serial # listed when u hit counter check/
go in service mode-
1) Press the User Mode key ‘*’ .
2) Press ‘2’ and ‘8’ on the keypad at the same time.
3) Press the User Mode key ‘*’ on the control panel.
select>>COPIER>OPTION>USER>CNT-DISP
and Use it to enable or disable the indication of the serial number in response to
a press on the Counter Check key.
Settings 0: enable (default), 1: disable
Seller may have it set at "1"
Last edited by teckat; 07-08-2011 at 03:32 PM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Your MFP will be a parts machine. Don't do it.
This is my "I told you so." =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Reply With Quote
Bookmarks