My canon 3170i keeps jamming paper on the first print. The paper gets stuck in the middle section in the side door. Any help is greatly appreciated.
My canon 3170i keeps jamming paper on the first print. The paper gets stuck in the middle section in the side door. Any help is greatly appreciated.
First check the drawer dials and make sure they are set right.
I found it. It looks like "fixing unit". Not sure if it is the right term. Yellow block in the middle of the machine when you open right side. The cover (with rollers, the one you pull back) on the unit is literally fried and cracked. What causes something like this? Where can i get this part?
IN service mode check:
COPIER>COUNTER>DRBL-1
Fixing roller..........Estimated life=100,000......FC6-6996
Pressure roller......100,000.........FC6-6997
Fixing upper frame unit..100,000..........FM2-0176
Fixing assembly....200,000.......FM2-0174...230V
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
if it looks cracked and fried then it might need to be replaced. Some parts were revised on the fuser unit because of bad fit. Rebuilt or new units with the updated parts will last.
the 3170 is an old copier now. Lows of warm up cycles for low usage could have caused an early death of the fuser unit. Updates to the firmware may have not been done either. Call a tech or throw it away.
Not sure why anybody would throw away a copier that has only 18k prints on it. Would you throw away a car that has 18k miles on it?
if a part is guaranteed to last, would not canon be responsible for replacing it?
If you have defective part,order a new one.Read PDF.......Binder2.pdf
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
Bookmarks