What the problem machine for this code E000001-0010, E000001-0001, E000732-0001, E000733-0001.These machines often have to code. when I reset the machine back in operation, but will be back problem. What is the real cause of this problem.
What the problem machine for this code E000001-0010, E000001-0001, E000732-0001, E000733-0001.These machines often have to code. when I reset the machine back in operation, but will be back problem. What is the real cause of this problem.
The Road will be Mastered by >>> the Going...
E000001-0010=The power has been turned off and then back on without resetting the error.
- Reset the error. (COPIER>FUNCTION>CLEAR>ERR)
E000001-0001=There is an error or an open circuit in the main thermistor, shutter thermistor, or sub thermistor.
- Check the connector of each thermistor or any fault in
connection and wiring.
- Replace the thermistor in question.
- Replace the DC controller PCB.
E000732-0001=There is a fault in the reader communication./There is a DDI-S communication error.
- Check the communication between the reader unit and the main controller.
- Check the power supply of the reader unit. (Check to see if initialization takes place at start-up.)
- Replace the reader controller PCB,reader relay PCB, or main controller PCB.
E000733-0001=There is a fault in the printer communication./There is a DDI-P communication error.
- Check the connection of the cable between the DC controller and the main controller.
- Check the power supply of the printer. (Check to see if initialization takes place at start-up.)
- Replace the DC controller PCB or the
main controller PCB.
Service Mode
1) Press the asterisk key (*) on the operation panel.
2) Press 2 and 8 simultaneously on the numeric keypad.
3) Press the asterisk key (*)on the operation panel.
COPIER > FUNCTION > CLEAR>ERR
Use it to reset an error codes
1) Select the item, and press the OK key.
2) Turn off and then on the main power.
WARNING
Be careful what u clear/ only use it on error codes if u have no experience on CANON PRINTERS
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Last edited by gensys; 07-18-2011 at 05:47 AM.
The Road will be Mastered by >>> the Going...
The theme is closed
The Road will be Mastered by >>> the Going...
Bookmarks