Hello I need the firmware too.
Can anybody send it to me or tell me where i can download it!
Hello I need the firmware too.
Can anybody send it to me or tell me where i can download it!
Hi
I have same problem if you email me i will thankful to you
sulemandw@yahoo.com
hello friends
i need firmware for canon ir2016j
send me it if u can to this email:aldweab2013@gmail.com
thanks
hello friends,
i've also the "donwload standby" message on my 2016. Can anybody support me with tools and hints please?
Thanks in advance.
Emailaulik80@googlemail.com
hi dude
i need this software for ir 2016
receportatas@gmail.com
pls send bro
thanks
Sorry guys for repetition, Few days ago I was trying to write new Boot Rom of Canon IR2016 with SST ver3.11 but failed since the 'DOWNLOAD STANDBY' still displayed on the machine. I succeeded to write new Boot Rom four different machine of the same model with this version of SST. I dont know where i went wrong since I've followed the procedure correctly,... Any suggestions? or maybe I need new version of SST apart from the one I have which is ver3.11? ...
Best Regards!
iR2016 & iR2016i use different firmware
are all models u have the same ?
what ver. of firmware do u have ?
2016/2020=v66.01.01
Main v66.01
BootROM v60.02
Language - -
PCL v71.02 [32M-OPT]
E-CNT v8.01 (Must change DC CONT PCB to upgrade)
Finisher-U1 v7.06
---------------------------------------------------------
2016i/2020i
Main v71.02.01
BootROM v60.02
Language v71.02
PCL v71.02 16M-OPT]
E-CNT v8.01 (Must change DC CONT PCB to upgrade)
Finisher-U1 v7.06
When upgrading the imageRUNNER 2016i/ 2020i copier to v70.01.01 the Language, and
PCL of the copier also needs to be updated to v70.01
Points to note when upgrading from ver. 10 or earlier to ver. 60 or later:
When upgrading from a previous version to v60.02, an “ALL Clear” will need to be performed. In order to back up the required data files, System Software v15.99 for the imageRUNNER 2016/ 2020 or v10.99 for
the imageRUNNER 2016i/ 2020i will need to be installed first. When “ALL Clear” is performed after System Software v15.99 for the imageRUNNER 2016/ 2020 and v10.99 for the imageRUNNER 2016i/
2020i has been installed, the following user information is deleted, so back up of all data is required beforehand.
- Address Book
- User Data
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
I've encountered this kind of problem before. what i did i replaced the image processor board. the one with backup battery in it/fram counter board.
hope it helps.
Please help me with firmware for IR 2016j.
email: dansdec@yahoo.com
thanks in advance
Bookmarks