Dear all,
In My IR6570 machine shows error code E 315 d. pls tell me the solution.
Thanks in advance
Regards
Binesh
Dear all,
In My IR6570 machine shows error code E 315 d. pls tell me the solution.
Thanks in advance
Regards
Binesh
firdaus +(62)8195002007 firdaustrish@ymail.com
I don't believe CCD Adjust has nothing to so with this,,, I fought this for quite awhile on a iR3320 years ago. It has to do with image data error on the main controller. The resolution to my long fought battle was to replace the memory on the main controller...
Good luck!
"Once a King, always a King, but once a Knight is enough!"
try to replace the SDRAM on main controller. hope this help.
If u have a Fiery S1 Connected make sure
the setting of Image Control is set to "4" in service mode -
Service Mode Level 1 ( * 2 / 8 * ) > Copier > Option > INT-FACE, highlight IMG-CONT, select 4, press OK.
Cycle the main power switch for the change to take effect.
or>>>>>>>>>>>>>>>>
Try performing a hard drive clear for '0'
To perform a hard drive clear:
1-Enter service mode level 1 by pressing Additional Functions 2 / 8 Additional Functions,
2-Select Copier > Function > System.
3-Next, select CHK-TYPE and press '0'.
4-Finally highlight HD-CLEAR and press ok.
Note:Always power cycle the machine after performing service mode adjustments
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Last edited by gensys; 07-28-2011 at 10:16 AM.
The Road will be Mastered by >>> the Going...
Bookmarks