do the steps that OxaK suggested and reply
do the steps that OxaK suggested and reply
check developing cylinder gear. i think developing cylinder not rotating or developing assembly out of toner.
It could be a scanner problem? Id give it a quick check shutter etc.
check your developing assembly locking lever
Is the developing cylinder rotating ?
Is there coating on the developing cylinder ?
(Check to see if the developing block members are in firm contact with the photosensitive drum.)
Is the transfer charging roller mounted properly ?
Is the connection of the transfer high-voltage cord normal? Is there electrical continuity in the transfer high-voltage cord? (The resistance of the transfer high-voltage cord is about 10 kΩ.)
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
I found the drum unit was not turning because of broken gear set.
This small part hard to find locally. It will take long time to get the machine back on operation. Thank you all....
where is that part located in printer ??
post a pic of location
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
brokenpartloc.jpg
Pls advise partnum and or partname,
and also advise the link for download the manual for installation
thank you.
firdaus +(62)8195002007 firdaustrish@ymail.com
Bookmarks