sorry for send cut off images i send a PG6 GRID TEST. i change two ITB, and make the same fault 4220_001.pdf4220_001.pdf
the paper is A4 normal
sorry for send cut off images i send a PG6 GRID TEST. i change two ITB, and make the same fault 4220_001.pdf4220_001.pdf
the paper is A4 normal
What firmware ver. is in your printer ???
THIS IS A MAIN SCAN ISSUE(CROSS-FEED>front to rear)
see a up close copy of your PG6
posters>double click on pic for better view
pg6.JPG
Auto-registration detection control refers to the previous control values and decides the next setting values. If the previous control values are off the range due to some errors (e.g. PCRG is not set correctly), the next control values are affected and the auto-registration detection correction cannot be performed appropriately.
DID U DO THIS PROCEDURE IN LEVEL 2 OF SERVICE MODE
your DCON ver.must be at least 21.04 to access this mode below
Service Mode: Level 2 > Copier > Function > Clear > Reg/Clear. Highlight Reg/Clear and press OK.
After performing the clear, reboot the machine and 1.perform a Gradation Quick Adjust
2.-and then a Full Gradation adjust.
IF that fails>>>>>
Before U perform a DC-CON clear, Print out your P-PRINT SETTINGS >power of/on and RE in-putt all DC-CON values after clear.
then POWER of/on
Last edited by teckat; 08-19-2011 at 04:22 PM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Hi
Did you manage to resolve this issue??
I have similar problem!
Thanks
Bookmarks