iRC3220 - ImagePass C1 - Disk Full

[MFPTech]

iRC3220 - ImagePass C1 - Disk Full message

Anyone has experienced this issue please and what was the remedy.



Thanks in advance!

[vigour]

most likely you will need a new hard drive eventually
if you are lucky you can get by with going into setup and erasing everything by doing factory default or some name like that, after printing your config page

[mrfixit51]

Is there a way to erase the print data area on the drive? The system area should not experience "bloat", but the print data area could be hosting lots of orphaned files...

[ReproKev]

On most fiery's you can go into setup and select "clear server". This will erase all print jobs on the hard drive and not touch the system software. I believe the C1 has this option also.

[zoraldinho]

You can clear the server by using the Server>Clear Server command in Command
WorkStation or the Server>Clear Server command in Command WorkStation LE. In
Command WorkStation, you can delete the following jobs individually: held jobs,
active jobs, printed jobs, archived jobs, FreeForm masters, and scan jobs.

Although the capacity of the HDD is changed, the system software and the installation method for it are not changed.

OLD HDD, 10GB WM2-5185-000

NEW HDD, 20GB WM2-5199-000

[charm5496]

On most fiery's you can go into setup and select "clear server". This will erase all print jobs on the hard drive and not touch the system software. I believe the C1 has this option also.

This should free up the needed space on the HDD. Load CWS if you do not have it loaded already and you can easily clear the server of all the data that has built up over time.

[vigour]

cLEAR sERVER

that is what i meant when i said factory default. sorrry could not remember the correct terminology

[MFPTech]

I was able to get the first screen and Cleared the server but then image Pass went to
"Printer Performing config Mode Settings" and Processing Data is flashing but nothing happens.

Could not log in with command workstation to remove stored files

[mrfixit51]

I was able to get the first screen and Cleared the server but then image Pass went to
"Printer Performing config Mode Settings" and Processing Data is flashing but nothing happens.

Could not log in with command workstation to remove stored files

Sounds like it is time for a clean install then. Hopefully you already have a configuration sheet print out from before this issue sprang up!

[charm5496]

If you plan keeping this unit for a while longer it would be worth your while to get a new 20GB HDD so you don't have to worry about another failure