Thanks: 
Likes: 
Dislikes: Hello everyone,
I have a canon imagerunner 2525ir and tried to set up the network card but i could not get into the Additional Function due to Admin Password etc
Can anyone please assist with this issue?
Many thanks for all your feedback
Hello everyone,
I have a canon imagerunner 2525ir and tried to set up the network card but i could not get into the Additional Function due to Admin Password etc
Can anyone please assist with this issue?
Many thanks for all your feedback
To the best of my knowledge, these are not born with an Admin Password, if it is like other imagerunner models, it has to be setup with one. My question would be, who set the password up on this device, and get that info from them...Originally Posted by pintechki
"Once a King, always a King, but once a Knight is enough!"
Lots of luck with the settings.
Default system password: user:7654321 , psw:7654321
Default technician password. 11111111
Control panel password: user: Administrator , psw: password
CANON !!!
Hey thanks for all your assistances, veru much appreciated
I will double check it and let you know the results
Cheers everyone
Default password for new Canon models is UN-7654321 and PW-7654321
I knew it was for the Advance boxes,, is this considered an Advance model, or are they going with a default one since the time the Advanced boxes have been developed???
"Once a King, always a King, but once a Knight is enough!"
I've installed a couple of the ir2525 and also the little irc 1021 equivelents and they seem to all be set with that same default password
Hey, I learned something new today!!
Now if I can only recall tomorrow what I learned yesterday...
"Once a King, always a King, but once a Knight is enough!"
you can though just enter enter svc mode clear password and get rid of that crap........far easier than a couple of phone calls a day from end user's 'forgetting this'
Reply With Quote
Bookmarks