My Canon iR C3200 is Misalignment, the colors are up and down like picture attech, Please help me.
one more thing, it is not print with PG10 or something.
DSC02365.JPG
My Canon iR C3200 is Misalignment, the colors are up and down like picture attech, Please help me.
one more thing, it is not print with PG10 or something.
DSC02365.JPG
If you took some time to search this forum, you would find at least a dozen discussions about this. Slipping ITB belt from dirty interior, old ITB belt that is stretched, worn ITB gears, old ITB clean blade, reseting laser adjustment cams to home position, clearing DC-Con (only after making sure you have either a P-Print or Label Print printout).
"Once a King, always a King, but once a Knight is enough!"
Last edited by truongson; 08-17-2011 at 02:45 PM.
Ok I will search for you
Teckat provided detailed info here and with all due respect to you I dont see why Teckat or anyone else needs to repeat what's already been posted
You are doing the hard part first, and it may not be needed, as CanonTech stated, start with the ITB first, go to lasers as a last resort when all other suggestions have been looked into, especially the life of the parts we have already spoken of. Is it time for a new belt, make sure it is clean inside the assembly? Blade? Worn gears? Do the easy stuff first...
"Once a King, always a King, but once a Knight is enough!"
it's not a PG10 or PG12 !!!!
U first need to print out a PG6 GRID PATTERN
next -when was the last time u did or do full auto-gradation ??????
here we go again- READ PDF>>>>-
???? What test print # is that ??? u posted-
iR3200 TP03-1.pdf
Last edited by teckat; 08-18-2011 at 01:44 AM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
This image I printed from Full Auto Gradation tool. But when I go to the service mode 1 -> Test-> PG type 6 or 8 or 10 or 12 then press Go , no thing happend, The printer dose not print.
I tried to clean everything and swap grears, change the blade but the colors still missalignment that why I tried to adjust the lasers cam. But I don't know where is the center position of lasers bar.
when printing a test page from service mode you have to choose a paper tray with paper in it to print from. Should be under PG-PICK. Default is tray 1.
Type int thest print (hit OK)
Choose paper tray (hit OK)
Then push the start key (Green circle)
try running a quick auto gradation as well
and which gears did you replace/swap? The drive gears that mount in the machine get worn and dirty and then do not mesh well with the drive gear on the rear of the ITB.
Also make sure that you reader unit that sits above the ITB is clean and sitting correctly above the belt.
Accidents don't just happen. They must be carelessly planned.
u need to resolve the issue > why u can not print out PG Test prints
do u have a paper tray set for plain paper ??
COPIER>TEST<PG>
PG-PICK
Used to select Cassette output level during test print output.
Setting values
1: Cassette 1
2: Cassette 2
3: Cassette 3
4: Cassette 4
5 to 6: Not used
7: Side deck
8: Manual feed
TXPH= set at 2
did u read my posted PDF , it shows the procedure
it shows the pictures like this one
3200_Laser gear.JPG
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks