TPM boards are also used in laptops. I have some more epeerience with TPM in these : Unless you replace a mainboard with a new one (you have to program/brand the serialno in them) you cannot use the TPM on another board. It's a securety measure to stop ppl from pulling data from parts of a system.
In the case of laptops : TPM + Mainboard + Disk -> replace either and data is inaccesable...
I guess if he printer is new and setup worked fine... maybe the TPM went bad ?
Johan
u can't swap Main pcb 1's -------poster created the E355-0004 code/ and E748-9000----level 3 will not clear the code with mismatch Main Pcb 1's
MNCON 1s are of different engine speeds between 6065 and 6075 and use different part numbers.
When you need to replace the Main Controller PCB 1, it is important to first ensure the proper model number of the device as the Controllers are different for each model.
As of 2016
All imageRUNNER ADVANCE Series / All imagePRESS Series / All imageRUNNER Series
Counter PCBs and SATA Flash PCBs are no longer available for purchase.
As a result, please handle E350 / E355 and E748 in the following manner:
E350 / E355 Error Codes:
Call the Technical Support Center (1-800-528-2830).
E748 Error Codes:
Refer to the Service Manual. If the Service Manual states, “Contact to the Sales Companies”, stop and call the Technical Support Center (1-800-528-2830).
*NOTE 1: For any of these error codes, do not swap any PCB's from any other machine. Doing so may render both machines unrecoverable.
*NOTE 2: Do not use any of the User Mode or Service Mode clears when encountering these error codes.
Executing the Service Mode or User Mode clears may render the machine unrecoverable.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
i have same error after i change board complete with old ram
Bookmarks