IR 2270 Removed Finisher- Need Output tray part #

[xeroid]

This finisher had multiple issues board and others with copies crashing through it. Customer never used it so I removed it. Now I get empty output tray and can't send anything to the inner output. Everything is diverted to the outer tray which doesnt have a catch. Can anyone hook me up with what I need to make this work? Any help is much appreciated.

[teckat]

This finisher had multiple issues board and others with copies crashing through it. Customer never used it so I removed it. Now I get empty output tray and can't send anything to the inner output. Everything is diverted to the outer tray which doesnt have a catch. Can anyone hook me up with what I need to make this work? Any help is much appreciated.

Additional Functions > Common Settings > Tray Designation.

Service Mode > Copier > Option > ACC > IN-TRAY > and change the value from 0 to 1

[mrfixit51]

If you had an external finisher, you have work ahead of you, as you need to replace the lower sensor flag, after removing the buffer pass unit. If you had an internal finisher you have to find both the upper and lower sensor flags and a bunch of plastic parts to cover the copier up as well as providing the inner tray, hopefully you have a cadaver copier you can scrounge from for the needed parts...

[teckat]

If you had an external finisher, you have work ahead of you, as you need to replace the lower sensor flag, after removing the buffer pass unit. If you had an internal finisher you have to find both the upper and lower sensor flags and a bunch of plastic parts to cover the copier up as well as providing the inner tray, hopefully you have a cadaver copier you can scrounge from for the needed parts...

I remember now , thanks- forgot u need those sensor flags back in & and other junk removed

[xeroid]

I remember now , thanks- forgot u need those sensor flags back in & and other junk removed

I need a parts list for this bad boy or just the page with the exit area. I bit off more thab I can chew right now with this project. Thanks for the reply

[mrfixit51]

I need a parts list for this bad boy or just the page with the exit area. I bit off more thab I can chew right now with this project. Thanks for the reply

Check your PM for listing!

[teckat]

I need a parts list for this bad boy or just the page with the exit area. I bit off more thab I can chew right now with this project. Thanks for the reply

1.- U removed the S1 finisher ?
Finisher S1 Install.pdf

2.- did u have the additional finisher B1 installed to it ??

what exactly did u remove ??

2270.JPG

these are the parts below that u remove & throw away when u attach a S1 FINISHER
click on pic for better view
Parts Needed.JPG

think this is what u need>
#7-Delivery Tray/FC5-1114-000
#6-Inner Rear Cover Lower/FC5-1106-000
#5-Inner Panel Rear Cover/FC5-0942-000
#4-Support Cover/FC5-1117-000
#3-Lower Cover Left/FC5-1108-000
#2-Lower Cover Right/FC5-1109-000
#1-Flag Full Detect/FC5-0798-000