hi geeting to all
ir5075 using finisher AD1 when doin sort and staple .paper came out skew.
pls advice me
thanks
hi geeting to all
ir5075 using finisher AD1 when doin sort and staple .paper came out skew.
pls advice me
thanks
hi
skew from finisher when using sort and staple.
thanks.any solution?
This issue can occur if there is no drive to the Upper Delivery Rollers. Turn off the imageRUNNER and turn on Bits 1, 2, and 7 of SW104 on the Finisher Controller. Turn on the imageRUNNER and then press SW103 on the Finisher Controller. The Swing Guide should then open and the Upper Delivery Rollers should be turning. If the Upper Delivery Rollers are not turning, check the Swing Motor M106 and also check the drive components between the Swing Motor M106 and the Upper Delivery Rollers.
KBase 025.jpg
Accidents don't just happen. They must be carelessly planned.
hi
should need upgrade firmware? pls anyone give me some technical bulliten.
thanks
READ THESE PDF's
AD1_TP07-1.pdf
AD1_TP07-3.pdf
AD1_TP08-2.pdf----this one has good info
AD1_TP09-1.pdf
Latest firmware for Finisher is – AD1/AD2 Fin-AD_STACKER_v0701.exe
this was in Firmware v52.01a and later ver.'s I believe
Upgrade the Finisher with the proper version using the PCB Downloader Tool
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
hi
pls anyone can email to me the firmware for finisher ad1 v 7.01.
citikris_1010@hotmail.com
thanks
u need the pcb PCB Downloader Tool (FY9-2034)
+ SST + printer firmware v52.01a or Later
for this operation- click on picture
tool.JPG
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
hi
i have the downloader but dont have firmware.anyone email to me citikris_1010@hotmail.com
thanks
Bookmarks