Creasing output on trailing edge of A3 only (about 2 inches) on iR3025
Clean up all fuser bearings... if needed fit new Silicon sleeve... and the final cure which i have had many successes with.. replace lower pressure roller. one thing for certain... it is fuser related! good luck mate..
Steve.
Clean up all fuser bearings... if needed fit new Silicon sleeve... and the final cure which i have had many successes with.. replace lower pressure roller. one thing for certain... it is fuser related! good luck mate..
Steve.
there is also a further adjustment you can make... service mode 2 - Adjust - Fixing - change FX-FL-SP to +3
(I'TS A FINE ADJUSTMENT FOR FIXING FILM SPEED)
Enjoy...
there is also a further adjustment you can make... service mode 2 - Adjust - Fixing - change FX-FL-SP to +3
(I'TS A FINE ADJUSTMENT FOR FIXING FILM SPEED)
Enjoy...
poster already used the previous suggestions / with success
read through the post
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks