When i turn on copier on display:Remaining data that is not needed is being erased.Do not turn of the main power.
Format HD
Installed new firmware
Clear m-con
Inspect ram
Any help.Thanks
When i turn on copier on display:Remaining data that is not needed is being erased.Do not turn of the main power.
Format HD
Installed new firmware
Clear m-con
Inspect ram
Any help.Thanks
your machine has the HDD erase installed in it
Accidents don't just happen. They must be carelessly planned.
I believe he is referring to the Hard Drive Erase security kit option that can be installed on copiers.
"Once a King, always a King, but once a Knight is enough!"
whenever you turn the power off/on on the copier the machine is going to go through that process where it erases all user data on the HDD to keep there information secure.
Accidents don't just happen. They must be carelessly planned.
But machine is just fine after 20 sec!!
How to delite this option please?
that option cannot be removed if I remember correctly. I think the only way to get rid of it is to install a new HDD and reload the entire system on the device. You will to physically remove the HDD erase kit from the device along with the current HDD.
The time it takes is dependent on the amount of data that has been stored since the last time the machine was power cycled.
Accidents don't just happen. They must be carelessly planned.
not a problem.
Accidents don't just happen. They must be carelessly planned.
Bookmarks