iR5570 E014-000 Fixing Motor Error. The shutter rotates freely on both directions, the gears in the back are good. Any ideas beside replacing the Fixing Motor please?
Thanks in advance!
iR5570 E014-000 Fixing Motor Error. The shutter rotates freely on both directions, the gears in the back are good. Any ideas beside replacing the Fixing Motor please?
Thanks in advance!
Check the Lower Fuser roller bearings .
Replace if needed>The part number for the Lower Fuser roller bearings are XG9-0636-000.
Check and Adjust the magnet on the front door to depress the front door switch fully.
(for your 24 volts to M3) to prevent interruption.
Check the front door interlock switch (SW2)
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
if you cannot find any cracked fuser gears, you need a motor no matter what we tell you.
they do not die often but they do die. i changed my second one ever yesterday.
remove plastic cover,
cheat the door switch
and watch it hesitate or struggle.
The PULL lock signal of the fixing motor does not arrive for 2 sec even when the fixing motor has been turned on.
In the first сheck up bearings(Lower Fuser)
In the second сheck the connector for any fault in connection.
Last edited by gensys; 09-16-2011 at 11:06 AM.
The Road will be Mastered by >>> the Going...
Yes check the motor how ever I think you will find the pressure roller and bearings shot. Almost all of my E014 are from this. I carry three sets of bearings and Press rollers and 1 motor
good luck
rb
you responded to a post from Four months ago
coffee.jpg
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks