CLC3220 convert to print as iRC3220n

[apollo]

Hi,
I have a customer with CLC3220 and dont have a fiery as they got donated the copier.
they are a charity and i am trying to help them.

Copier works fine but they would like to print to it.

I have installed |BOOT ROM N vesion and have upgraded the all the firmware.
The BOOT ROM N as well.
Enabled the network option on the screen.

I can ping to the copier from PC, but when i installed printer drivers and try to print
i get no joy.

I even Tried with my laptop with Canon fix Ip address 172.16.1.100 and copier on FIX IP mode no joy.
The copier can be pinged no problem.

I would appreciate any help.

Thank you..

[alex@wocltd.com]

you have removed the i/f board and replace with the surf?

[KL568]

You also need to access copier's Service Mode to change from "3" to "0" for following setting :

Copier > Option > Body > IMG-CONT

A restart of the copier is needed

[apollo]

i have changed IMG-CONT to 0, but will try installing the surf board and will feed back .
thanks

[apollo]

I have installed surf board from another copier, but still no joy in printing.
I can ping the copier no problem, but when i send a print job nothing happens.
Not even processing message.
Maybe is there something in the service mode i have to enable?

Thanks

[songela]

Upgrade the RAM, also find if COPIER > DISPLAY > ACC-STS > PS/PCL = 1

[teckat]

I have installed surf board from another copier, but still no joy in printing.
I can ping the copier no problem, but when i send a print job nothing happens.
Not even processing message.
Maybe is there something in the service mode i have to enable?

Thanks

did u re-input your network settings in Additional Functions>System Settings
Network.JPG

make sure u have the Color Network Multi-PDL Printer Kit-A2 BOARD installed/
for the imageRUNNER C2620/C3220


and not the Color Network Multi-PDL Printer Kit-A1 Board installed/
for the imageRUNNER C3200




Send Function=needs
Color Universal Send Kit
& Resolution Switching Board

Fax Function=needs
Super G3 FAX Board
& Resolution Switching Board

PDL Print Function=needs
Color Network Multi-PDL Printer Kit
or imagePASS

[apollo]

Thanks for your replies.
Yes i have input the ip address from control panel addtional functions etc...

I installed the surf card, boot rom N, and network card from
Canon irc3220 working copier from workshop..

thanks

[teckat]

Thanks for your replies.
Yes i have input the ip address from control panel addtional functions etc...

I installed the surf card, boot rom N, and network card from
Canon irc3220 working copier from workshop..

thanks

Copier can be pinged but you can not open RUI or print to it
does the RUI no print also effect you not printing ??

Problem may be caused by the IP address Range setting being set to on but no IP address was specified.
To check or change the IP Address Range settings select Additional Functions > System Settings > Network Settings > TCP/IP settings > IPv4 > IP Address Range settings and set all options to Off.
In this screen there are 4 sub menus, [Reject IPv4 Address], [Permit IPv4 Address], [Reject IPv4 Address] & [Permit IPv4 Address]. Go into each one of these sub menus and set them to Off.
Next power cycle the copier and test.


have u tried a MMI Clear ???