and my problem is that u are not a tech/
I posted some SERVICE MODE adjustments
Setting in service mode
[9] Wait time reduction mode-Used to decrease the print start temperature by 15°C to reduce print time; for iR5000, 4 min or less; for iR6000, 1 min or less.
[10] Priority on fixing mode-Used to switch the down sequence temperature; increases the fixing temperature by 10°C.
[11] Priority on productivity mode-Used to switch the down sequence temperature; decreases the fixing temperature by 10°C.
[12] Thick paper mode (120/230-V model only)-Used to increase the fixing temperature at the start of printing to 203°C or higher to improve fixing (after power-on, 211°C in M/L mode).
[13] Special paper mode - Used to hold printing unit if the fixing temperature reaches 180°C for special paper.
COPIER>OPTION>BODY>FIX-TEMP
Use it to select down sequence mode.
0: OFF, 1: priority on fixing while controlling down sequence temperature to +10°C for all,
2: priority on productivity while controlling down
sequence temperature to -5°C for all
CHECK
Heat discharge fan (FM3)
Exhaust (lower rear)
Bookmarks