1Likes
LinkBack URL
About LinkBacksHey guys this is a long shot would anyone have an old NP1550 to take the exit detection sensor and cable off to help me out pls
Hey guys this is a long shot would anyone have an old NP1550 to take the exit detection sensor and cable off to help me out pls
A little knowledge is a dangerous thing
I think I see that CLC-500 falling out of the back!!!! LOLOriginally Posted by zoraldinho
Accidents don't just happen. They must be carelessly planned.
ah thanks guys if only i could
Are you sure it's NP1550?
I remember a AIO version of the NP1215, retagged as the NP1500. Maybe it's the same thing?
If it is an NP1500, I think it was a reed switch, and the heat used to make them intermittent.
Sorry, I tossed all that stuff 5 years ago. =^..^=
blackcat: Master Of The Obvious =^..^=
Do a continuity/meter check on the cable you can repair that quite easily if it’s broken.
Also the exit sensor is the same as many other sensors in the machine, swap it with say the stack feed sensor, I doubt the customer uses that on this old machine. I still have got dozens of new sensors in stock if you need any.
Reply With Quote
Bookmarks