-Normal Mode (download mode B)
turn on the main power while holding down 1+7; then, make the following selections in service mode:
COPIER>FUNCTION>SYSTEM>DOWNLOAD
-Safe Mode(download mode A)
turn on the main power while holding down 2+8
Capture_011.jpg
Installing the System Software
The system software that has been downloaded by the SST (version 3.01 or later) is saved in the temporary storage
area of the HDD. You must then turn off and then on the main power switch so that the system software will be
written to the system area, boot ROM, and flash ROM when the machine starts up. When you turn off and then on
the main power switch for a second time, the machine will start up using the new version of the system software.
[Registering the System Software]
1) Start up the PC.
2) Set the system CD in the PC.
3) Start up the SST.
4) Click [Register System Software]
5) Select the drive in which you have set the System CD, and click [SEARCH].
6) The list of system software found on the System CD appears. Remove the check from the folders and software
you will not need; then, click [REGISTER].
7) When the result of registration is indicated, click [OK].
Making Connections
[Procedure]
1) Start up the PC.
2) Check the network settings of the PC.
- At the command prompt, type 'IPCONFIG', and press the Return key.
- Check to see that the network settings are as follows:
IP address: 172.16.1.160
subnet mask: 255.255.255.0
default gateway: any
3) Check to see that the Execute/Memory lamp on the control panel is off, and turn off the main power switch
(iR4570/3570, 2870/2270 Series).
3-1) Hold down the power switch on the control panel for 3 sec or more.
3-2) Follow the instructions indicated on the control panel so that the main power switch may be turned off.
3-3) Turn off the main power switch.
4) Connect the PC to the machine using a cross cable (iR4570/3570, 2870/2270 Series).
5) Start up the machine to suit the download mode you will be using (iR4570/3570, 2870/2270 Series).
- Normal Mode
Turn on the main power switch while holding down 1+7.
When the machine has started up, make the following selections: COPIER > FUNCTION > SYSTEM >
DOWNLOAD.
- Safe Mode
Turn on the main power switch while holding down 2+8.
6) Start up the Service Support Tool.
7) Select the model of the machine to connect (iR2270/3570).
8) Click [START].
Capture_012.jpg
Capture_013.jpg
Capture_014.jpg
Bookmarks