clc 1180 w/colorpass z400e

[gmamadog]

i have just removed my print and interface boards from my old clc 1140 and installed into my clc 1180. i am trying through service mode to tell the machine that there is a rip attached / service mode - options - int-FACE - B-CLR. everytime i try to change B-CLR to "1" telling the machine that there is a rip attached, it resets the value to "0", no rip attached. any ideas or suggestions?

[charm5496]

The CLC's are not like the Image Runner series where you have to go into service mode for the Fiery connection. I am trying to find old documentation as it has been so long since we have sold a CLC device, but I do know that the setting you are trying to change is not the correct one. I will post back if I find the info I am looking for.

[charm5496]

try setting copier>option>int-face>remote to a '2'

[gmamadog]

thanks for the effort. i went into config mode on the rip and printed a test sheet. it has been working fine since then.

thanks again!

[DANIELCANON]

no es nesesario hacer ningun cambio solo conecta los cables y envia tu pagina de prueba y funcionara sin problemas.