I am getting dirty copies only on duplex
need to know how to clean duplexer area
and duplex feed path
any help will be greatly appreciated
thanks Walt
I am getting dirty copies only on duplex
need to know how to clean duplexer area
and duplex feed path
any help will be greatly appreciated
thanks Walt
pull it apart and clean with the chemicals that you have????
What kind of "dirty copies" are you getting on the back side? Usually this is a drum/developer or fuser issue. Dirty guides normally give you dirty edges.
Accidents don't just happen. They must be carelessly planned.
the dirty copies only on duplex side
gets better when you make many blank copies
I'm thinking the fuser unit when it comes for the second pass
thanks
yes I would pull out the entire unit as toner likes to build up on it anyway. Take a good look at your cleaning roller and your film.
Accidents don't just happen. They must be carelessly planned.
Clean every thing you can see. There will be toner debris on the paper for awhile after cleaning up a messy machine. Is the drum leaking towards the back? Sometimes if they let the drum leak or use it when its really streaking waste toner can get into the transfer roller area and can cause some dumping on the papers . Can also block a sensor under the charge roller. You can see four posts that hold the transfer asembly to the door. Take that apart to clean. You could take the door off first and get better feel and look at the duplex path.
Toner may leak from the sub hopper unit or developing assembly to inside the machine
The shutter of the hopper assembly is adapted to open when the edge of the developing assembly pushes the shutter
lever at the rear side of the machine in response to forward movement of the developing assembly. Because of this
mechanism, in the case that the shutter lever is not pushed enough when the developing assembly is inserted into the
machine, a clearance that permits toner to escape is created between the hopper and the shutter.
New FC5-1253-000 SEAL, ENTRANCE
New FC8-1089-000 SEAL, HOPPER AUXILIARY
When the machine is running, the toner may leak from the area around the toner delivery mouth between the sub
hopper [1](P-1) and the developing assembly.
To prevent toner leak at the hopper assembly, the foam rubber sheet [2](P-1) is attached to the sub hopper [1].
Capture_033.jpg
If you have soils at the leading edge:
Capture_034.jpg
1.If the above symptom occurs, replace the upper transfer guide [2] with the new type of upper transfer
guide(FL2-0304-030).
Capture_035.jpg
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
Thank you all Very much
I have Canon IR3035 and I'm getting blank print and copies. When I change the drum it prints for a day or so and then it starts to give me blank paper again. Has anyone ever had such as problem?
Pay special attention to the fuser inlet guide. In a "dirty" machine as described above by the other guys , the inlet guide is a prime culprit. Take it off and remove the hard toner as well as giving it a clean.
Only other addition to what has been said already is to change / clean your door filters.
Yes, I am a nerd.
Gaming PC - check. Raspberry Pi - Check. Custom ROM on phone - check. Thick glasses - check.
Bookmarks