ir3300 not passing paper

[Dalamar]

Canon has no Logic
while in service mode/ did u try to print out a test page ?



you quoted this statement above in your first post

is this still happening when you send a Print or do a Glass Copy( paper leaves the tray)

Only pulls from tray when you try to make a glass copy, otherwise it does not pull paper.

[Dalamar]

I've now also swapped the mcon and dcon with no changes.

Anyone have any idea?

[charm5496]

have you checked your fuser temp in service mode? I'm wondering if the machine is having a difficult time maintaining the proper temperature and therefore the machine pauses before moving the paper to the drum and then to the fuser assembly.

You could have a wiring issue to.

[teckat]

I've now also swapped the mcon and dcon with no changes.

Anyone have any idea?

Back to Basics !!!!!!!!!!!! answer these questions ?

1-No Error codes ?
2-No Jam codes ?
3-Can u make a test print in service mode ?
4-U can make a copy of the glass - yes or no ?
5-Can u make a print from the network ?
6-Can u make a copy using DF - yes or no ?
7-When u keep open the cover and hit print key- does the scanner move to scan the entire document ?

does any paper ever exit the FUSER ???

try this------------
boot into Download Mode using the 2&8 keys/ & let me know if u get in download mode or if it says -"Cannot Initialize" ?

[joju]

i have one doubt for canon old model canon NP 6045 error code E 031 any budy knows how to reset this error pleas helpe me thanks

[teckat]

i have one doubt for canon old model canon NP 6045 error code E 031 any budy knows how to reset this error pleas helpe me thanks

U sure it is E031 ????

even though this code points to option counter, it can be caused by a short / check wiring to DC Controller-
& check for your 24v on front door switch
were u working on printer before code ?????


E031----(The option counter has an open circuit.)
When the accessories counter is off, an open circuit is detected in the
accessory counter--

check connector/wiring/ or replace counter or DC PCB could be bad

also check below for broken wires or short to frame
Electromagnetic clutch (CL15) for vertical path drive (harness broken)- Short ???