IR1023IF "download standby"

[RSCA]

Comes to this condition at power on. I can't get any response anywhere. In the history this same thing happened in February and the tech "reloaded batch". Is this software available? Is it worth it if it keeps coming back? Thanks for any info.

[teckat]

Comes to this condition at power on. I can't get any response anywhere. In the history this same thing happened in February and the tech "reloaded batch". Is this software available? Is it worth it if it keeps coming back? Thanks for any info.

do it again


v68.01.01 for the imageRUNNER 1023/ 1023N/ 1023iF Copiers

<Points to note>
(1) If upgrading from an older version to v60.03 (or later), the BOOT area is increased.
At the same time, the SYSTEM writing start address (FLASH-ROM) is changed.
The SYSTEM writing start address is included in the BOOT v60.03 and later, so after BOOT has
completed downloading, turn OFF and ON the power, so that the new SYSTEM writing start address is
reflected.
Upgrade procedures
<Without options>
1. Overwrite BOOT.
2. Check that "OK" appears on the touch panel display. Then, turn OFF and ON the power manually.
(Download mode starts.)
3. Overwrite SYSTEM.
<With OPT16MB>
1. Overwrite BOOT.
2. Check that "OK" appears on the touch panel display. Then, turn OFF and ON the power manually.
(Download mode starts.)
3. Overwrite OPT16.
4. Check that "OK" appears on the touch panel display. Then, turn OFF and ON the power manually.
(Download mode starts.)
5. Overwrite SYSTEM.
<With OPT32MB>
1. Overwrite BOOT.
2. Check that "OK" appears on the touch panel display. Then, turn off and on the power manually.
(Download mode starts.)
3. Overwrite OPT32.
4. Check that "OK" appears on the touch panel display. Then, turn off and on the power manually.
(Download mode starts.)
5. Overwrite SYSTEM.

or replace the IP (Image Processor) pcb

[dellt]

you have to upgrade your firmware with SST