Thanks:
0
Likes:
0
Dislikes:
0
-
Field Supervisor
500+ Posts
- Rep Power
- 34
Ir4570 feeder adjust
hello ,
canon IR4570 i need information how to adjust the feeder of it how to adjust the margin up and down left and right
also if how can i adjust the margin of the casette in program .
-
Re: Ir4570 feeder adjust
The margins on the feeder can be adjusted with service mode > Feeder > adjust > doc stop.
This will move the image in the direction of the arrows
1.jpg
- if the image is displaced to the leading edge, decrease the setting.
- if the image is displaced to the trailing edge, increase the setting.
unit of adjustment: 0.1 mm
The top and bottom margins for each cassette can be adjusted in service mode level 2 > Copier > adjust > misc C1/2/3/4-ADJ-Y
This will move the image in the direction of the arrows
2.jpg
C1/2/3/4-
ADJ-Y
Entering a horizontal registration adjustment value for Cassette 1/2/3/4
Enter the horizontal registration adjustment value for Cassette 1/2/3/4.
Enter the laser writing start position on the paper picked up from Cassette 1/2/3/4,
based on the registered value.
An increase by +1 enlarges the front margin by 0.1mm.
<Note>
When clearing RAM of the DC controller PCB or replacing the PCB, enter the
service label value.
Last edited by skynet; 12-07-2011 at 08:34 PM.
-
Field Supervisor
500+ Posts
- Rep Power
- 34
Re: Ir4570 feeder adjust
Thanks man
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks