Results 1 to 4 of 4
  1. #1
    Technician
    Join Date
    Dec 2011
    Location
    Tamil nadu, chennai
    Posts
    12
    Post Thanks / Like
    Rep Power
    6

    Thumbs up AnyOne Please Help me....

    i am facing error code e00064-0000 IN IR 3300 MACHINE, I HAVE REPLACED THE DRUM, AND ALSO CHECKED THE HVT PCB, STILL THE PROBLEM OCCUR, PLEASE ANY ONE GUIDE TO SOLVE THIS ISSUE THANKS IN ADVANCE....

    THANKS AND REGARDS
    MADHUSEL


  2. #2
    Field Supervisor 2,500+ Posts


    zoraldinho's Avatar
    Join Date
    Mar 2008
    Posts
    2,954
    Post Thanks / Like
    Rep Power
    52

    Re: AnyOne Please Help me....

    E064-0000


    The presence of a high-voltage error is communicated by the composite
    power supply PCB. (The output for primary charging, developing, or transfer
    has deviated from a specific level of voltage.)

    Main cause The contact has poor connection. The wiring is faulty. The composite power
    supply PCB is faulty. The DC controller PCB is faulty.


    Action

    1. Contact

    Is any of the contacts of the primary charging roller, developing assembly,
    or transfer charging roller soiled? Or, is there poor contact?
    YES: Clean the contact, and set it once again.

    2. Wiring

    Is the wiring between the contacts for the following normal: DC controller
    PCB (J301), composite power supply PCB (J136), primary charging roller,
    developing assembly, transfer charging roller?
    a. DC controller PCB (J301) <-> composite power supply PCB (J136)
    b. composite power supply PCB (J130-7) <-> primary charging roller contact
    c. composite power supply PCB (J130-1) <-> developing assembly contact
    d. composite power supply PCB (FT133) <-> transfer roller contact
    NO: Correct the connection.

    3. Composite power supply PCB, DC controller PCB

    Try replacing the composite power supply PCB. Is the problem corrected?
    YES: Yes.
    NO: Replace the DC controller PCB.

    A little knowledge is a dangerous thing

    Click here to be sure



  3. #3
    Trusted Tech 50+ Posts dhanesh's Avatar
    Join Date
    Jun 2010
    Location
    Thiruvananthapuram, KERALA
    Posts
    63
    Post Thanks / Like
    Rep Power
    0

    Re: AnyOne Please Help me....

    did u reset error and ram clear?

    DHANESH

  4. #4
    Service Manager 250+ Posts mramlawi's Avatar
    Join Date
    Jul 2011
    Posts
    459
    Post Thanks / Like
    Rep Power
    11

    Re: AnyOne Please Help me....

    once Happen with me at the same machine and it was weakens on Electricity so check the power of the Socket try to plug it directly without any extanstions.

    regards

    Distinguished road makes you jewel in rough

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here