I'm servicing Canon IR2020 The machine after I turned on from main power wsitch and I put the IP address it started to Boot ON and OFF by itself and it keep repeating and I can't do anything. Any idea about what's going on?
I'm servicing Canon IR2020 The machine after I turned on from main power wsitch and I put the IP address it started to Boot ON and OFF by itself and it keep repeating and I can't do anything. Any idea about what's going on?
Power off printer>Check the LAN pcb on the Image Processor pcb, > remove/unplug it to test >power up with out LAN Pcb--This is the pcb that the network cable plugs into and is also referred to as the NIC (Network Interface Card) by some people.
u may need to Replace the LAN pcb FM2-4058-000 to correct the problem.
if printer stays booted up with out it plugged in
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Try replacing the RAM. Had a brand new ir2800 working fine then died after inputting an IP address. After swapping a bunch of parts the RAM brought it back to life. I must have RAM on my brain lately.
Bookmarks