iR C2620 with ImagePass C2 trouble

[vigour]

look carefully your ip is.....
169.168
gateway is......
192.168

those 2 do not go together 169/192 ( they should be the same )

if you have no gateway leave it as dfault 127.0.0.1
or make an ip address on the proper subnet.

what is the ip address of your pc?

[Smartmind]

Hi,



This actually indicate that Fiery is unable to get any IP address from router. Set this "Enable auto IP Configuration(Yes)" to NO. Then you will be able to specify a static IP of your choice network, if I'm not wrong in the range of 169.168.1.xxx

Thanks very much for helping, i finally made it work.

[Smartmind]

Hello Guys! I just want to tell thanks to everybody for helping, finally we did fix the machine. the only little problem now is that the color photo printed have some burned ink spots, i did check the fixing Unit and i found the rolers presure screw a little loose, i did tried to fix it. the picture got better but still not perfect. i did autogradation, but pictures are not perfect yet.

[teckat]

Procedure for performing NIP-CHK on Color ImageRUNNER machines?

• If the finisher is attached and connected, remove it from the copier and pull out the lattice cable.
• Place LTR size paper in the MANUAL FEED TRAY.
• Enter Service Mode FUNCTION>FIXING>NIP-CHK.
• Press the OK key and the paper in the manual feed tray is fed.
• When the fed paper is pressed by the fixing roller, it stops, and is delivered about 15 seconds later.
• Check that the nip width of the delivered paper is the standard value. (Cyan is used for this test)
• Adjust as needed to meet specification using the procedure outlined below.

The steps above typed in BOLD are "added" steps for technicians who typically work only on CLC machines or with limited IR knowledge.

NIP.JPG

[Smartmind]

Thanks to everybody, my machine is working pretty much good.

[teckat]

super-tech-support.jpg