Thanks: 0
Likes: 0
Dislikes: 0
Single sided is fine. When doing 2 sided from glass, thru adf or mailbox 2nd side off about 1/4 inch in the cross feed direction. Thats after adjusting adj-refe to -50, the highest setting. I'm suspecting horizontal reg motor m3 but havent gotten e051 codes. Wondering if any of you have had this. TIA
I can't remember if the iR3300 has a horizontal registration sensor. It was really common on NP-3030, NP-3050, and NP-4050 to have toner dump into that optical sensor. As a consequence the horizontal registration motor always ran all the way to the end. Now it surprises me that you don't see the effect on the first side, but I suppose it's possible.
The only thing that pops up in the database is a separate adjustment for DADF main scan registration, second side. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
I believe there is a sensor but it doesnt usually get dirty. If I'm right its on one end of the pfu by the motor. I played with that df adjustment. It helped copy thru df but off glass and print doesnt change. I'm gonna go back with a motor and try my luck.
Replaced horizontal reg motor and that fixed it.
Thanks for following up. Congratulations. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Posting Permissions
Reply With Quote
Bookmarks