Thanks: 
Likes: 
Dislikes: Actions taken so far:
new Laserunits
new DC-PCB
new Main1 & 2 Controller
all Cables and Pins checked.
After Init Rotation the Error comes upand is permanent.
Any suggestions??
iRADV5035i Machine displays E100-0300
Actions taken so far:
new Laserunits
new DC-PCB
new Main1 & 2 Controller
all Cables and Pins checked.
After Init Rotation the Error comes upand is permanent.
Any suggestions??
Originally Posted by canone
did u pt back your original settings>
E100-0300: BD error (laser scanner unit 2) CYAN_BLACK_
When the Laser Scanner Unit 2 (CBk laser) is started or print operation is processing, if the BD signal cannot be detected after the specified time.
Scanner Motor (C, Bk)
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
E100-0300: BD error (laser scanner unit 2)
The BD signal cannot be detected when the Laser Scanner Unit 2 (C,Bk laser) is started or print operation is processing.
This model is equiped with two lasers : Laser Scanner Unit 1 ( left assembly) for Yellow and Magenta and Laser Scanner unit 2 (right assy)for Cyan and black. They've the same number: FM3-5425-000 for iRAC5030/5035. So, take care to replace unit 2 in your case. You can also interchange their position and verify if the error extention has changed.
Good luck.
Rachid.
"Find a job you love and youll never have to work a day in your life." Nagy's father
Hi,
thx for the infos, Clears were made and new laserunits changed. IŽll check the Powersupply.
Did you fix this fault .got the same problem .replaced dc con & bk/c laser .also showing error for yellow .
this is an intermittent fault
Hello,
Has this issue been fixed please?
I just got a call with exactly the same error - going there in a couple of hours....
Cheers,
Did you ever figure this out? I have a new C5235 with this error. I have already replaced the laser unit.
intermittent error happens several times a day. I'm stumped, and busy!
Canon has released new firmwarelease to fix this issue. Please update to latest and greatest.
Thanks. I thought the firmware was done by previous tech... Not the case. Firmware was still at 19
will confirm when complete.
=====================
swap lasers to see if an error changes over to yellow & magenta
latest for that series is v31.01.01
E100-0300/ dont' see any update for E100-0300
common remedies are checking connections and shutter related inspections
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Posting Permissions
Reply With Quote
Bookmarks