Hello,
There is no HDD.
Rachid.
Hello,
There is no HDD.
Rachid.
"Find a job you love and you’ll never have to work a day in your life." Nagy's father
-----------------------------------------------------------
u should not be receiving message about IP address
-u must have printer off
connect laptop to printer>then open/start up UST
-now power up printer
if a found new hardware pops up >select cancel
Press the Additional Functions key on the control panel of this machine to enter into the user mode.
-Press the down-arrow key to select "System Settings", and then press the OK key.
-Press the down-arrow key to select "Update Firmware", and then press the OK key.
-When "OK to update" appears, select “Yes” and then press the OK key.
-When "PLEASE WAIT WAITING" appears, start the UST.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
i have message *mode bios " ir2422 please help me
I have a problem with the printer Canon IR2318. Please tell me where to get UST?
I have a problem with the printer Canon IR 2318. Please tell me where to get UST application?
please can you send me this file iR2520_30-V0023-UST-boot.exe
khaled.kps@gmail.com
i need to update my Canon IR2520 Firmware
pleace can you send me this file iR2520_30-V0023-ust-boot.exe
my mail: asdcv1995@gmail.com
thanks a lot!
What is your scenario ( series of actions and events ) on printer
Blank display
green led on and no cycle of engine
On a fully working device, J8125 (Main Controller) measures as follows:
Pin 1 - 0v 7 - 5v
2 - 3.2v 8 - 5v
3 - 3.2v 9 - 5v
4 - 0v 10 - 0v
5 - 0v 11 - 24v
6 - 0v
When the iR is in Blank display, green led on and no rotation or if DC Controller or Boot Rom is defective or J210 or J8112 is not connected.
J8125 measures as follows:
Pin 1 - 0v 7 - 5v
2 - 3.2v 8 - 0v
3 - 3.3v 9 - 0v
4 - 0v 10 - 0v
5 - 0v 11 - 0v
6 - 0v
If the imageRUNNER is in the Blank Display state and listed voltage is missing on J8125, there is no way to isolate the issue to one of the listed components.
Start with cleaning and re-seating the Boot Rom, reseat connectors J210, J8112 & J8125, cut any wire ties on the related harness.
This instance of the Blank Display was resolved by replacing the Boot Rom.
Part number for the Boot Rom: FM1-B884-000
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
This is what happen. Ir2545
At first its intermittent error 248. at first error is cleared by power off-on. then suddenly at power on the machine cannot start-up or boot. the green light on the control panel is ON, the canon logo appears on the display. (you can hear the machine motors rotate then stop) The progress bar on the canon logo STOPS at the middle and stays there, as it hangs there.
Action taken: reseat boot rom, reseat plugs on terminals of dc con and main. still the same problem.
Do you think i need to flash or reprogram the machine?
i encounter same symptoms with a konica 7033 before and i solved it by reprogramming or re install the firmware. But this time it is a CAnon IR2545
By the way, i have also a IR 2530. are the boot rom of IR 2530 and IR 2545 the same. I have not yet open the ir2530 to compare their part numbers?
Bookmarks