Thanks: 0
Likes: 0
Dislikes: 0
I have an image runner 5065 that is creasing the paper. I haven't been there yet but customer say is it only does it when doing 2 sided copies. I first assumed lower bearings but has anyone seen wrinkling only doing 2 sided? I am still leaning toward lower bearings. There is an image inside the wrinkles so this tells me that paper is straight passing under the drum. She says the copies are not skewed either. Just looking for input as i cant be there until monday....thanks all!
She says?? Take a look first.
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
That is, what she said :-)Originally Posted by zoraldinho
She says?? Take a look first.
When on site,observe the following:
-check on the heater roller bushings,
-check on the lower roller bearings and the lower roller itself,
-check on the corona wires on the transer corona assembly in case they are old replace.
Good luck!
Also, check the entrance guide to the fuser. Toner build up can cause the paper to skew before entering the fuser and crease the paper
Check the small bearings on the ends of the Steel Roller located in the Duplex Feeder Unit, check also for flat areas on the Sponge Roller.
Bearing XG9-0192-000
Steel Roller -
FB5-3322-020
Sponge Roller -
FB5-3321-000
Yes, it sounds like its time for a fuser rebuild.
Hey guys, I wasn't notified of replies and hadn't checked the site. I agree that she can be mistaken. I will let you know.......Thanks
Well, she was correct. It only creases when doing 2 sided. pulled the LFR and the front bearing is shot and the LFR shaft is worn very thin. Have one on the way. Don't know why it only does it on 2 sided, but, oh well, used to want to figure out "why". Now I just repair and move on, lol.
Nice find.
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
Posting Permissions
Reply With Quote
Bookmarks