IPF8300 Hardware Error 2F48

[Phil B.]

Is there somebody here that can fix the mainboard for the ipf8300 ? i got 4 that need to be fixed heheeh

check with Hy-Tech

[cxpcman]

check with Hy-Tech

is this one ?Factory Authorized Circuit Board Repair by Hytec Dealer Services, Inc.

it will be nice if someone can repair and send back. that mainboard problem is very common.

[Phil B.]

is this one ?Factory Authorized Circuit Board Repair by Hytec Dealer Services, Inc.

it will be nice if someone can repair and send back. that mainboard problem is very common.

Yes.. that is co.
DISCLAIMER: Not sure if they repair/send back or send a diff one repaired.
Used them for decades.. good peeps.
Check with them on your issue

Sent from my SM-G960U using Tapatalk

[teckat]

is this one ?Factory Authorized Circuit Board Repair by Hytec Dealer Services, Inc.

it will be nice if someone can repair and send back. that mainboard problem is very common.

---

800.883.1001

-

407.297.100

Call Hytec to check

[cxpcman]

well i end up ordering a new mainboard from item inc.
but problem still there im really out of ideas now.
the damn problem persist.
somebody can help me cool my head troubleshooting this problem ?
what i have done so far :
heads and carriage board
power supply pcb
Mainboard
flex cable

Yes.. that is co.
DISCLAIMER: Not sure if they repair/send back or send a diff one repaired.
Used them for decades.. good peeps.
Check with them on your issue

Sent from my SM-G960U using Tapatalk

[silviu_25]

iPF8300 Firmware Ver.1.26
Canon U.S.A. : Support & Drivers : imagePROGRAF iPF8300




March 26, 2012

iPF 8300 / 8300S

2618, 2F48, 2F49, 2F50, 2F51 or 2F52 Error Code

If the printer has the latest firmware installed (Ver. 1.25 or higher - iPF8300 Series), you only need to do the following:

1. Check if the Status Print or Print INF files indicate which print head experienced the error and replace it.
2. If the specific print head failure cannot be determined, replace both print heads.

NOTE:
With the latest firmware installed, it is no longer necessary to replace the Carriage Relay PCB. Make sure to apply the latest firmware updates to all of the printers.
September 25, 2012

iPF 8300 / 8300S

2F48 Error Code
In one case both print heads and the Carriage Relay PCB were replaced to resolve the error code.
PROCEDURE:

1. Turn off the printer and remove the current print heads
(DO NOT INSTALL THE NEW PRINT HEADS AS YET)
2. Replace the Carriage Relay PCB (QM3-3121-000).
3. Power the printer back on in User Mode without the print heads, then install them when the printer requests.
4. Follow all printer instructions to continue booting.

------------------------------------------------------------------------------------------------

Hi, I ust changed Carriage Relay PCB, Head Management Sensor and Multisensor due to 2f48 on my IPF8300,
now I have 2f25.
Any Idea what to do?