Canon IR 6000 JAMS AT FUSER:

[teckat]

Here's what IKON said I needed:

"Your 6000 needs AT LEAST....
Feed Tires
Separator Roller
Cam End Plate
Can Mounting Spring
Cam Mount
Cam Level
Cam Plate
Total Fusing Assembly
Corona Assembly
Primary Corona Assembly
Clutch
Pre-Transfer Corona Assembly
And about three or four hours labor to rebuild the machine. (Not sure on that....)
Again, these are the parts to just get it going so we can see what else it needs to be brought up to specs. So, I think it's a no brainer to replace this machine."

Instead, Thanks to This site I fixed Everything myself for NO cost and No parts required!
THANK YOU ALL!

////////////////////////////////////


Sounds like a former Canon Salesperson from DANKA >
turned IKON Salesperson>turned into a IKON/RICOH TECH

[ybnews]

////////////////////////////////////


" Sounds like a former Canon Salesperson from DANKA >
turned IKON Salesperson>turned into a IKON/RICOH TECH"

WOW! You are Exactly correct.

[syed009]

Today I removed the top fuser station from the machine and changed out the upper fuser heat roller at my work bench.
Also replaced the right hand slider rail that the unit slides in and out on. It was broken.
Put it all back together and now the machine jams just as the paper begins to hit the fuser rollers. Doesn't matter which bin I feed from.
No codes showing up. Just regular "Open Right side door, open main door, clear jam" message.
I hand wind paper thru the fuser rollers via the green turning knob to clear the jam and start again. Same thing keeps happening.
Did I knock something out of position? or a Sensor? or a motor?
Lil' help...
Thank you for your attention.
Dana

first check the drumunit screw and check the duplex feeder sensonrs and horizontal sensor and wire connections in duplex