[Error Code] Ir3225 is giving E 611-000

[Alex ahir]

what is this code ? is it related to memory.

[teckat]

Re: Ir3225 is giving E 611-000

what is this code ? is it related to memory.

----------------------------------------------
E611 Error Code

CANON
The code indicates a problem with the SRAM.

try the JUMPER procedure First (see below)

--------------------------------------------------



Try jumping the Main Controller at JP1, then restarting the copier, the Main Controller was able to be cleared. The imageRUNNER then booted normally.
------------------------------------------------------
In some particular cases, Jumper JP1 on the Main Controller, was shorted, to resolve the issue. Below is a picture of the Main Controller with an arrow that points to JP1.
Note:
Be sure the power is turned off, when shorting the pins together at JP1.


--------------------------------------------------

If this error returns, clear the data for partitions 1, 2, 3, 4, 5, and 6. To clear the partitions, perform the following steps:

1) Enter Service Mode.
2) Go to COPIER>FUNCTION>SYSTEM
3) Change the value of CHK-TYPE to a 1 and press ok.
4) Select HD-CLEAR and press ok.
5) Change the value of CHK-TYPE to a 2 and press ok.
6) Select HD-CLEAR and press ok.
7) Change the value of CHK-TYPE to a 3 and press ok.
8) Select HD-CLEAR and press ok.
9) Change the value of CHK-TYPE to a 4 and press ok.
10) Select HD-CLEAR and press ok.
11) Change the value of CHK-TYPE to a 5 and press ok.
12) Select HD-CLEAR and press ok.
13) Change the value of CHK-TYPE to a 6 and press ok.
14) Select HD-CLEAR and press ok.
15) Restart the imageRUNNER

Note: The HD Clears will remove user data from the Hard Drive. Address Books, Mail Box Data, Network Settings, and other user data will be lost.

warning***************************
Hope u have those settings saved somewhere