Hi all,
I have a problem in CLC 3220, the machine always display (please waiting), after clearing the dc cont and MMI, plz I need your suggestion about this problem,
Regards
Hi all,
I have a problem in CLC 3220, the machine always display (please waiting), after clearing the dc cont and MMI, plz I need your suggestion about this problem,
Regards
==================
Displayed When Sending Print Jobs
does printer come to READY & then go into waiting
or does the opening splash bar hang up & say please waiting
u just can't clear DCON without having a P PRINT with the DCON settings to put back in printer/
do u have a Fiery connected ??
if so =Try re-seating the Open Interface Board
how old are the DRUMS ??
Check to see if the Fuser unit is coming up to temperature.
Then check to see if the drum unit(s)are not past the life expectancy.Replace the drum unit(s) if needed.
could be caused by a loss of communication between the DDI-S PCB Board to the Main Controller.
remove memory & clean ends >then re-seat
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Hi,
==================
Displayed When Sending Print Jobs
- · Displayed after reboot the startup .
does printer come to READY & then go into waiting
- · No still waiting
or does the opening splash bar hang up & say please waiting
- · No , the opening splash bar end and open new window then waiting to warm up
u just can't clear DCON without having a P PRINT with the DCON settings to put back in printer/
- · I print the p print before cleared the DCON but I cannot enter the service mode by *28*
do u have a Fiery connected??
- · Yes I have a fiery c1
if so =Try re-seating the Open Interface Board
- · I will try
how old are the DRUMS??
- · All the drums counter are low reading
check to see if the Fuser unit is coming up to temperature.
- · I touched the fuser unit the temperature was high
Then check to see if the drum unit(s) are not past the life expectancy. Replace the drum unit(s) if needed.
·
could be caused by a loss of communication between the DDI-S PCB Board to the Main Controller.
- · I don’t think, because it was working before clear the DCON and MMI,
There was a problem in the copy or print out, a shadow of the letter in both mode, I changed the ITB but not solved, one of my friend suggest to clear the DCON and MMI , so I did
remove memory & clean ends >then re-seat
- · I will try
Thanks for your support
Have you set IMG-CONT back to 3 after doinging the performing the clear? do you have the printer tab on the top right of your screen?
Verify that the copier is set to 'imagePASS mode' (IMG-CONT = 3): 1. Enter Service Mode by hitting Additional Functions, 2 and 8 simultaneously, and then Additional Functions.
2. Select Copier > Option > INT-FACE > IMG-CONT.
3. Set IMG-CONT to 3 and hit OK.
4. Reboot the copier.
* When IMG-CONT is set to 0, the copier is set to use the Canon Printer Kit controller. The Printer tab will not be displayed.
When IMG-CONT is set to 3, the copier is set to use the imagePASS controller. The Printer tab will be displayed.
-----------------------
great point on re set/ overlooked that MMI Clear by poster
Copier > Option > INT-FACE > IMG-CONT
Reminder to poster >
>power off printer> then remove all the Fiery connections> power up printer get into service mode ( U NEED TO BE QUICK> u may have to try a few times) then do procedure to re set fiery as posted by Canon.Tech.
1-after re set/ power off>connect back fiery>power on>
imagePass C2 Install.pdf
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks