Not much to go on description-wise from you but from the looks of the pic I'm guessing you have a frozen progress bar during bootup.If you are not a tech....now would be the time to call one. You can try reseating DDR-SDRAM) on the main controller PCB. If that doesn't help.....possible hdd failure or main board.
Anything can be made to work if you fiddle with it long enough- San Diego Copier Repair.com
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
I have a main board and ram for sale
Pull out transport drawer,open all covers,doors,pull out the process unit(disconnect all connectors).Disconnect finisher and all accessories. Leave front door open and see if it boots. I have seen cleaner blade vibration motors cause dead machine,machine won't boot full properly,all sorts of weird stuff. Clean the contacts on the ram,etc with fine sandpaper and alcohol
This person has clearly been zapped inside the display screen of the machine and is looking for help to escape his imprisonment.
Thanks everyone, it was concluded that the wire is grounded.
But the problem I have left off. I want to program the firmware please send it to me.
Bookmarks