OK,so The Plot THICNKENS! lol
I hooned around with some wires, probed a few pins, plugged in and out some plugs and have now got shot of the Close upper cover error!!!!
But...........
start the machine normally and it comes up with Multi sensor error turn off and wait a while, do that, no change.
Start her up in service mode, get to putting some paper in then it says....no R Printhead installed! WHAT!!!
So removed the multi sensor (the thing with the LEDS?) all clean. made sure printhead was in and locked down, which it is.
What is going on!! lol
T
Bookmarks