IR 1600 pickup problem in bypass

[Guna]

In IR 1600 when the paper feed from bypass try the paper just pick up and stop near to drum and the paper jam.I check the manual clause bypass pickup sensor but the problem not solve.Can any body fix the problem ?

[teckat]

In IR 1600 when the paper feed from bypass try the paper just pick up and stop near to drum and the paper jam.I check the manual clause bypass pickup sensor but the problem not solve.Can any body fix the problem ?

jam code ----------- error code

all paper sizes

jam from bypass only ?
is this issue from PC Printing or glass copying ?? or both

[Guna]

Nothing any error code only paper jam indicate.
All size paper jam only when paper feed from bypass .And it is happen both from glass scaning and also computer prints.
Pickup from all trays is ok.
Regards
Guna

[teckat]

Nothing any error code only paper jam indicate.
All size paper jam only when paper feed from bypass .And it is happen both from glass scaning and also computer prints.
Pickup from all trays is ok.
Regards
Guna

=================
1-Does the holding plate move up in keeping with pickup timing?
2-Is there damage/foreign matter on the gear of the pickup roller
drive assembly?
3-Does the multifeeder pickup solenoid operating normally?
4-Is the manual feed separation pad worn?



PS105 multifeeder paper sensor did u check it ????????????????? (lower right)
photo interrupters may be checked using ‘SENSOR’ under ‘TEST MODE’ in service
mode (6-3: SENSOR).

did u check the #10 REPORT= Jam/Error Log Report
Indication : JAM/ERR LOG REPORT
Type : jam, error, alarm history

or Alarm History
040017=multifeeder retry alarm


How many jam indicators are lit on control panel