Hello, everyone, I Encounter an Error Code E00227-001, I replace Image Reader power supply, Image Reader Cable.. but still same problem.
Anyone can give an idea on how to rectify this problem...
Thanks in advance..
Hello, everyone, I Encounter an Error Code E00227-001, I replace Image Reader power supply, Image Reader Cable.. but still same problem.
Anyone can give an idea on how to rectify this problem...
Thanks in advance..
e227 is 24-volt is off at powerup. Could be Power Supply FM2-5544-010 or Main Power Supply {FM2-0216-020}. Could also be a pinched wire that's dragging down 24volts. I'd look for the pinched wire first before changing boards.
-----------------------------------
added to suggestions
do u have anything else using that supply voltage outlet that is tied into Printer Outlet
check your OUTLET for the correct voltage supply for your printer in your area--
HOT>GROUND=
HOT>NEUTRAL=
NEUTRAL>GROUND= this should be 0v/0.5 Max
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Every tech should have one of these handy. Especially when you go to install one. First thing I do is run up, pop this in and verify that the plug is indeed wired correctly.
Gardner Bender GFI-3501 GFCI and Receptacle Tester | Canadian Tire
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
hello,
Thank you very much on your interesting reply..
Only one that I notice, if i open the right door or front door there is no error occurs, the machine will go to initialize status and it shows close door (front or right door, which is open)..
I have question.. On the front door there is a sensor (PS23), after I disconnect that sensor my machine is working fine.. there is any affect on my machine? and what that sensor for?
thanks & Regards....
-------------------------------------------------------------------------
U sure U have the correct sensor ??-------------
Behind the front cover (is process unit) ???????????
Cassette 2 paper level sensor A (PS23)
PS23.JPG
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
hello sir,
Sorry sir, it's PS17 front door sensor, right down corner of front door, near double switch door, there is a photo sensor. that's the only one that I removed and then my machine working fine until now, almost 2 weeks now...
Thanks
-----------------------------------------
w/o finisher
to tray 1 No. 1 delivery sensor (PS27)
to tray 2 No. 2 delivery sensor (PS1A)
to tray 3 No. 3 delivery sensor (PS5A)
PS5A No. 3 delivery sensor
DC controller PCB > J742-9 to 11 (Extension delivery controller PCB)Jam codes= 010B/ 020B/ 0A0B
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks