Canon ir 105, copies are with background in zoom, normal copies are ok. i did ccd adjustment etc.but problem still there, what could be the problem pls help.thanks in advance.
Canon ir 105, copies are with background in zoom, normal copies are ok. i did ccd adjustment etc.but problem still there, what could be the problem pls help.thanks in advance.
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
It comes any percentage of zoom,mostly customer makes zoom to make copies of id cards.we already adjust ccd with white paper on glass.
-------------------------------------
on the primary HVT there is a small switch, try to flip it and background gone ??
Did u try to Decrease the value in the following ?
in service mode:
COPIER>ADJUST>AE>AE-TBL
u could do a normal scan of the card/cards into a PC then > print from PC to 105 at a zoomed %
id there a security Hologram on the id card
place a OHP transparency sheet on the glass> then place the ID card on top of it> now run a zoom copy
Last edited by teckat; 09-15-2013 at 03:15 PM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
I followed sir teckats advice copy is some what better but still there is back ground while making zoom copies of id cards.
i already tried the photo mode, but still it gives background.
thanks
---------------------------------------------
what happens when u enlarge normal text documents to same ratio used on id cards ????
do these OD Cards have a Matt Finish or a Smooth Finish
what is ZOOM RATIO U USE ?????
is it a solid background or when enlarged do u see fine lines
-keep AE off
-set PRE-TR to 165 and reboot
-try replacing the Lamp
-Check the Drum to make sure the drum heater is on and is warm. With a piece of paper in the palm of your hand, reach up and feel the drum with the paper acting as a heat shield. If ON the drum should feel warm.
If not try setting SW3 at rear-lower-right to full-wave ( right dot pushed in). Re-check drum warmth again in a few minutes.
Check the wiring harness in the front of the AP kit for continuity. A poor connection through the harness may cause the Pre-Exposure lamps to turn on intermittently.
Clean the scanning lamp, reflecting plate, side reflecting plate, mirrors,
lenses, and dust-proofing glass-
THEN----
Execute the following in service mode:
1. COPIER>FUNCTION>CCD>CCD-ADJ
2 COPIER>FUNCTION>CCD>LUT-ADJ
Try to Increase the value in the following
service mode: COPIER>ADJUST>CCDSH-TRGT (max. at 160)
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks