Thanks: 0
Likes: 0
Dislikes: 0
SYSTEM ERROR E007
MY COPIER REPORTS SYSTEM ERROR AND AS SUCH CAN NOT PRINT.
I HAVE TURN OFF & OFF TO NO AVAIL, IT KEEPS TELLING ME SYS ERROR.
SOME TIMES WHEN I TURN IT ON OFF OR LEAVE IT FOR THE NEXT DAY,
IT MAY PRINT BUT AFTER THAT, IT REPORTS THE SAME MESSAGE.
WHAT CAN i DO TECH?
CANON C-IR2016
Fuser film torn. Replace upper fuser assembly or entire fuser
---------------------------------------------Originally Posted by Alphonse
if u are a tech/ remove FUSER UNIT to inspect
if damaged replace as noted by Brian8506
don't forget to clear ERROR in service mode
make sure green jam release lever is installed with the new unit.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Fuser Film error,
If fuser film is intact, clean the white patch on the film usually it gets dirty and wont be read by the sensor
hi tech done all that still to no avail---------------------------------------------
if u are a tech/ remove FUSER UNIT to inspect
if damaged replace as noted by Brian8506
don't forget to clear ERROR in service mode
make sure green jam release lever is installed with the new unit.
still say system error
and the display screen shows partly the message.
so can copy the error code, it ends with 7.
please help
You replaced the fuser but still NG? If you can't see half the display, you need to replace it so you can see the whole error code
Replace the fuser, if the film is intact then the film is not rotating at the proper speed when machine is running.
Reply With Quote
Bookmarks