Canon ir3570 fax problem

[mramlawi]

Dear all,
i wonder if some one face same problem befor,i have a canon ir3570 and i want to install a fax board for it ,so i installed all what the fax need,the problem is when i plugged the line cable ,i heard a pulses from speaker and didnt stop what should i do is theres a somthing must do ,should i do system software or reset for something . Thanks

[canonbundy]

Dear all,
i wonder if some one face same problem befor,i have a canon ir3570 and i want to install a fax board for it ,so i installed all what the fax need,the problem is when i plugged the line cable ,i heard a pulses from speaker and didnt stop what should i do is theres a somthing must do ,should i do system software or reset for something . Thanks

Super G3 Fax Board Q1.
Installation Procedure.pdf

[bramar]

Super G3 Fax Board Q1.
Installation Procedure.pdf

I just want to check if you resolved the problem with FAX??? I have the same problem and cannot find the answer. I'll check fax board.

[canonbundy]

I just want to check if you resolved the problem with FAX??? I have the same problem and cannot find the answer. I'll check fax board.

The following is very important.

1.3.1

Type Settings 0007-2908

Make country/region settings of the FAX board in service mode (FAX>Type>TYPE).With the settings, parameter will be set to meet the communication standards for each country/region.

1.3.2

Basic Settings 0007-2909

In this section, make only minimum settings required for FAX communication.- User Phone NumberAdditional Function Key > [Communications Settings] > [User Settings] >[Unit Telephone #] > Enter fax number > [OK]- Telephone Line TypeAdditional Function Key > [Communications Settings] > [User Settings] >

[Tel Line Type] > Select a type of line connection > [OK]

[bramar]

The following is very important.

1.3.1

Type Settings 0007-2908

Make country/region settings of the FAX board in service mode (FAX>Type>TYPE).With the settings, parameter will be set to meet the communication standards for each country/region.

1.3.2

Basic Settings 0007-2909

In this section, make only minimum settings required for FAX communication.- User Phone NumberAdditional Function Key > [Communications Settings] > [User Settings] >[Unit Telephone #] > Enter fax number > [OK]- Telephone Line TypeAdditional Function Key > [Communications Settings] > [User Settings] >

[Tel Line Type] > Select a type of line connection > [OK]

Thank you for you answer. I've checked that already, and I have to inform everyone that the problem is solved. I connected phone line to Line 2 instead on Line 1, and everything works out of the box.